How To Cut Fiberglass Reinforced Wall Panel

You can use a jigsaw to cut the fiberglass paneling if you use a blade made for cutting metal.

How to cut fiberglass reinforced wall panel.

Stretch the tape measure along the frp sheet and place a mark along one edge of the frp panel with the carpenter s pencil at the length. Put on your safety glasses particulate respirator and leather gloves. Easily use jigsaw to cut the fiberglass paneling but you use a blade made for cutting. Put on your safety glasses and dust mask to protect your eyes and lungs while you work.

Your cut will only be as good as your line. Transfer this measurement to a sheet of fiberglass wall paneling and. Fiberglass is hard and will quickly dull any wood cutting blade. All you need it s a sharp knife and a heat gun.

The jigsaw will work better than some other saws if you need to saw curves in the panel. Clean your work surface thoroughly to avoid scratching the front of the panels. For a better cut use a clamp to hold the panel in place. How to cut a fiberglass wall covering for bathroom paneling 1.

Frp looks like it should be really easy to cut but the fiberglass component makes it much harder. Tools options are shown below. Use a carpenter s square and a straightedge to get a perfect line. The jigsaw will work better than some other saws if you need to saw curves in the panel.

Then set 1 panel at a time face down onto the cutting table or a pair of sawhorses. Measure the wall area where you plan to install your fiberglass panel. Don t try to cut the frp all the way through. Lay the frp panel flat on a table that.

Clamp it down if necessary. Sometimes referred to as a skill saw the circular saw works well if you re cutting a straight line and if you re using a blade with fine teeth. After having the marked line you arrange the blade of the carbide circular saw with the chalk line by pressing the trigger of the circular saw and slowly shove the blade in the frp sheet. When shoving the blade across the frp panel you still need to align the chalk line and the blade of the carbide circular saw.

In a pinch you can just slice into the panel with a good sharp knife and then fold back and forth along the slice.