How To Dismantle 2008 Suburban Rear Door Panel

Do the same to all the snaps.

How to dismantle 2008 suburban rear door panel.

When re installing push the knob down until the detent tab touches the locking rod opening cover. Step 1 locate the access panel for the mirror s wiring harness and mounting nuts. Remove the door panel using the common screwdriver. For more info go to.

Robert dana shows how to remove a door panel on 2007 2014 chevrolet truck escalade suburban tahoe silverado. Pull the cover off the inner door panel using your hands. You need to remove the door panel for a number of differen. It s also probably the same procedure or a similar procedure for rear doors on the yukon xl suburban as well as the four door sierra and silverados with the ltz denali or slt trims.

Use a flat bladed tool to disengage the detent tab and then remove the knob by pulling upward. Place the common screwdriver at the top of the panel in between the door panel and the door. The panel is usually triangular and mounts inside the door frame directly opposite the location where the mirror housing bolts to the outside of the door. Slide the screwdriver down until it contacts the snap and pry the snap out of the recess in the door.

To save your positions in memory do the following. Driver s door panel and are used to program and recall memory settings for the driver s seat outside mirrors and the adjustable throttle and brake pedal. In the video 1a auto shows how to remove or replace the interior door panel trim on your vehicle. Adjust the driver s seat including the seatback recliner and lumbar both outside mirrors and the throttle and brake pedals to.

There are snaps on all three sides of the panel. For more info go to.