How To Fix Old Garage Door Spring

The general process is simple and safe.

How to fix old garage door spring.

Put on eye. Once the spring is free of tension remove from its track hanger. Disconnect the garage door opener so the door remains closed. If your garage door cable is at an angle or l.

Test the spring by lifting the door about 3 feet. This video is to inform you of a type of spring and bracket that exists on one piece garage doors with a jam pivot style design. Install the new spring reinstall the pulley and reconnect the safety cable and you re done. Adjust the springs on both sides of the door the same way.

Step 1 unplug the garage door opener and clamp the door to the track. Diy garage door repair and save money. Retest the door balance as you did in step 1. If it was opening too quickly move it to the next lower hole.

Lubricate the spring with garage door lubricant then remove the clamp from the garage door. Disconnect the spring from the track bracket and the spring pulley and disconnect the safety cable from one end. Pull the cable as tight as possible before tightening the setscrews. Use locking pliers or a c clamp to secure the door to the track to keep it from opening when you release the tension on the springs 1 x research sourcestep 2 loosen the set screws while holding each spring with a winding bar.

Leave the locking pliers in place and repeat the tightening procedure on the other side. Position a sturdy ladder to the side of the springs rather than working directly in front of them for safety reasons. If the door remains in place the replacement was a. This system is unsafe and sh.

This video will show you how to repair a mis aligned garage door cable. Snap a locking pliers onto the torsion tube to lock it into place while you tighten the drums.