How To Install A Lock On A Hollow Door

A lock block is a solid piece of wood that is pre built into hollow doors so that you have a solid section of wood to drill your lock into.

How to install a lock on a hollow door.

Use the drill to screw pilot holes and attach hinges to the door. Step 4 install door knob and latch. Use masking tape to affix the template at the proper position. Once inserted a small key is used to open the anchor which spreads out interior brackets to clamp the collar of the anchor against the door face like a toggle bolt.

How to install a deadbolt into a hollow core door. Always use bolts instead of. The main thing to remember is that most interior doors are called hollow core. Insert the anchors into the holes in the door and tap the top of the screws as necessary with a hammer until the back of the hook is flush against the door.

Use a sharp point to mark the centers of the two hole positions for the lock cylinder through the face of the door and the latchbolt into the edge of the door. Attach the interior part of the deadbolt lock by inserting the two provided long screws through the interior plate the two screw holes in the bolt and into the exterior side of the lock. Scrape away remaining wood. Place one of the deadbolt plates on the door to figure out exactly where it should be.

Always check before you start drilling and cutting and refer to any manufacturer s instructions. This means that they are not solid wood and this might pose a problem with the strength of the deadbolt. Use the chisel on a low angle to prevent digging deeper than necessary. Snap on the decorative outer plate.

This section will either be built in on the side or will run from the top to the bottom of your door. Mark the center of the holes for both the lock cylinder and latchbolt. Decide where to install the deadbolt on the door. Drill 1 8 inch holes through the door at the machined holes install the bolts and fit the washers and nuts on the ends of the bolts at the inside face of the door.

These plastic anchors fold flat to fit inside a pilot hole drilled into the door. If mounting into a solid door simply secure the hook to the door with retaining screws. Using the original hinges if possible place the hinges and make sure the hinges are level with the door. Measure from the edge of the door to the center of the circle on both sides to make sure the.

Hand thread the screws then tighten them using a screwdriver or power drill.