How To Install Metal Roofing On A Steep Roof

Cut the shingles to fit around the flange s dome.

How to install metal roofing on a steep roof.

Preparing for a safe job on a steep metal roof requires an assessment of the roof before the job begins. It isn t hard as long as you are careful take your time do it right and be safe. And for any exposed fasteners try to avoid over tightening them. Take your first sheet of.

If the plumbing vent is close to the peak of the roof lap the shingles over the peak of the roof. A careful inspection will identify potential hazards and will give. Adhere the joint where the cut edges of the shingles meet the dome with roofing tar. Try to space the screws about 12 inches apart down the entire piece of metal.

Install the roofing screws vertically along each rib in the panel. Use your 1 1 4. Some roofs are so high and so steep that even working from scaffolding can be dangerous. Adhere the shingles adjacent to the flange with roofing tar.

Align the first metal roofing panel so that it overlaps the edging by 1 2 to 3 4 of an inch and is square to the roof line. Moreover try to ensure that the screws are all aligned evenly. To watch the entire series from the beginning click here. You will use metal roofing screws to secure the metal panels to the sheathing.

A roofing harness provides the extra security you need when working on such a roof. Be sure the larger edge is laid so that the small edge of the next panel will overlap it.