The tools needed are readily available at your local home improvement store.
Installing roof vent flashing.
Cut some membrane material to seal between the vent flashing and the roof and cut an opening for the vent.
Roof flashing is standard around any pipe vent.
Begin by removing the shingles at the affected area and removing old flashing if present.
If you do not wish to form your own corner flashing you can buy pre bent pieces and cut them to size or use a piece of corrugated aluminum which is easier to bend.
Apply a thin bead of silicone around the opening of the vent pipe area and lay the membrane in place.
Then nail the new l shaped flashing under the builder s felt but above the fascia board.
Bend the corner flashing tightly around the corner.
Roof shingle over step flashing.
Drip edges are strips of flashing material that run along roof eaves and rakes to prevent water from seeping under the finished roof along its edges.
1 remove nails holding down shingles above the pip.
Next use a reciprocating saw with a rough in blade to cut the out the marked template.
Pull the old flashing up over the vent pipe and scrape any old caulk and debris off the roof.
After selecting an area to install from inside the building square the template between the roof rafters and outline with a marker.
Installing a new pipe vent flashing is easy and can be done in a short time.
Step flashing on roof peak.
Vent pipe flashing fits over flues or pipes.
Using a sawzall cut any roofing nails in the area of the lower mounting plate flush with the sheathing.
The shape of vent flashing is typically a cylinder with a wide flange at the base which is lapped into the shingles as the roofing is installed.
Center the pipe in the flashing and push the flexible front corners up or down so that the flashing pipe is parallel to the vent pipe.
It s soldered to a roof flange that layers into the shingles.
However over time the flashing can wear out and allow water to penetrate the interior of your home.
Use roofing nails to install the l shaped flashing flush with the roof and wall then cover it with roofing cement and reattach the roofer s felt.
Step 1 climb to the roof.
Slide the new flashing over the vent pipe and under the shingles above the pipe.
The traditional pipe flashing is a soldered lead riser pipe that encloses the vent pipe and folds in the pipe at the top.
