How To Disassemble Spring And Pulley Garage Door

Remove the garage door springs.

How to disassemble spring and pulley garage door.

The garage door wire cable can come off of the drum pulley spool which can be quite frustrating to repair. Do not try to remove the extension spring that is not broken when the garage door is closed. This will prevent the door from shooting up and breaking your nose when you wind the new springs during an overhead garage door repair. Since extension springs are determined by how much weight they each lift and the pulley system cuts this in half you need to replace your old springs with 200 pound extension springs.

Extension springs are located above the upper tracks on both sides of the door torsion springs are attached to the header directly above the closed door. Install the new spring reinstall the pulley and reconnect the safety cable and you re done. 19 cheap garage storage projects you can diy. Open the door manually to the point where you can t open it but don t force it past this point and make the problem worse.

Torsion springs are always under tension and can be very dangerous to. Also yank the cord and unplug the garage door opener before you start any garage door spring repair. There are two types of spring mechanisms. The door will likely also be uneven.

Get free estimates from garage door spring repair. Once in place disconnect the garage door opener. Disconnect the spring from the track bracket and the spring pulley and disconnect the safety cable from one end. In this video i have a look at how to repair the.

Garage door springs alone cost 30 to 100 for a torsion spring and 20 to 50 for an extension spring. Garage door spring repair costs 40 to 150 for a tune up or replacing cables. Garage doors use springs to carry much of the weight of the door during lifting and lowering. Garage door spring replacement costs 140 to 350 for torsion springs and 120 to 200 for extension springs.

Open the door to relieve the spring tension and secure it open with c clamps in the tracks. When a pulley is worn the corner of the garage door will often catch on the broken pulley preventing the door from opening. Use a piece of tape to mark the current placement of the pulley so that it. Open the garage door.

Open the garage door to remove all spring tension and clamp it in place. The general process is simple and safe.